|
#1
05-13-2012, 05:00 AM
| |||
| |||
 Transition to Larger Flue - Does it Matter? I am building a 35 inch pompeii oven and have been working on installing a 6" flue. The transition is finished and it reduces to a little under 6" x 6". The ratio of door area to flue area is about 14% But... I have just seen a good condition stainless steel flue that is 9" diameter I am confident I can install the bigger flue over the 6" x 6" square hole but I am just concerned that it may not draw well with it going down to 6"x6" and then expanding to 9"dia. Can anyone give me some advise if it will be a problem... Thanks Brett  |
 |
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Steel Dome Oven | Wiley | Other Oven Types | 193 | 03-10-2013 03:40 PM |
| Vent transition for clay flue liner | azatty | Design Styles, Chimneys and Finish | 16 | 07-24-2012 08:11 PM |
| flue to chimney transition | gtofani | Tools, Tips and Techniques | 2 | 11-06-2011 11:28 AM |
| Vent to Flue Transition Question | DimTex | Design Styles, Chimneys and Finish | 13 | 10-03-2009 05:09 AM |
| Flue Chimney Tips | Alf | Design Styles, Chimneys and Finish | 1 | 08-02-2005 07:07 AM |
All times are GMT -7. The time now is 05:42 AM.
Powered by vBulletin® Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
Search Engine Friendly URLs by vBSEO 3.6.0
© 2006/10 Forno Bravo, LLC
