Tip - Thermocouple Hole
Posted by Tim Cole on 12 April 2014 05:00 PM

Hello , 

We understand you wish to know how to drill a hole to support a converstion to Gas on your oven.

You can reference your Commercial Installation guide, but for you convenience, we have included 2 photos.

One showing someone drilling the hole with a 3/8" Drill bit using an impact drill.

The other showing the position of the hole relative to the dome.

The hold location should be at 3:00 on the oven.

Thank you for choosing Forno Bravo!



Attachments 
 
 pic_thermocouple_hole.jpg (459.04 KB)
 pic_thermocouple_dome.jpg (343.40 KB)
 pic_thermocouple.jpg (692.73 KB)
(0 votes)
This article was helpful
This article was not helpful

Comments (0)
Post a new comment 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako Resolve