#1  
Old 06-08-2006, 02:58 PM
james's Avatar
Brick Oven Merchant
 
Join Date: Mar 2005
Location: Pebble Beach, CA
Posts: 4,648
Default Vent design

The question of vent design come up frequently. Here is a sticky posting that address some of those questions.

There are two fundamental ways to build your vent, both of which are very common. There is no right or wrong:

Open, where you attach a steel vent to your enclosure walls, frame it in, and leave the walls open. This method give a specific design look had has the advantage of leaving you a large, open oven landing.

Closed, where you enclosure the vent sides with brick or a wall. The vent landing has it own entry arch (from any material). The method gives you a traditional look. If you want a larger work space in front of the oven, you can space the side walls wider than the oven opening; you can angle the walls outware, and you can build a second oven landing in front of the vent landing.

You can build your walled-in vent in one of four ways:
1. Build the entire assembly out of brick.
2. Have a metal vent fabricated, and build it in with walls or bricks.
3. Buy vent pieces from Forno Bravo.
4. Cast your own vent pieces using refractory concrete.

Hopefully the attached graphics help make this clear.
James
Attached Thumbnails
Vent design-anatomy.gif   Vent design-brick_oven_vent.jpg   Vent design-brick_oven_vent1.jpg   Vent design-metalvent.jpg  
Attached Images
 
__________________

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by james; 03-25-2007 at 07:59 AM.
Reply With Quote
  #2  
Old 02-21-2007, 05:23 AM
Serf
 
Join Date: Jul 2006
Location: Orange, Massachusetts
Posts: 4
Default Re: Vent design

It seems that access and visibility into the oven would be considerably better with the open vent (hung with no side walls) design. But would this design hold heat less well? It seems that the vent enclosure on the closed vent design would help minimize heat loss from the oven by direct radiation (?) and convection (by shielding the oven door from drafts). Is this one of those difficult design compromises, or are these issues not real?
Doug
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 12:17 AM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC