| Pizza Ovens | (800) 407-5119 | info@fornobravo.com | U.S. Price List |
![]() |
![]() |
| | LinkBack | Thread Tools | Display Modes |
|
#1
| ||||
| ||||
| My plan is to have my barbecue the same height as the hearth floor. I am now wandering if my approach has compromised the strength. The plans have a little more than an inch of concrete below the steel and above the block where I have the steel setting on the block - hopefully the picture helps this make sense. Do you think the sheer strength of the steel alone is adequate to support the weight? Thanks, Les... |
|
#2
| ||||
| ||||
| I'm good I had a PE run the numbers and the design will work. If I had it to do over though, I would have bent the steel 90 degrees into the block and then tie it to a vertical bar. Come to find out the sheer wasn't the issue - it was the pull out.Sometimes thinking outside the box is a lonely place. |
![]() |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Measuring your Hearth | james | Getting Started | 19 | 10-28-2010 05:25 PM |
| Sanity check | Les | Getting Started | 6 | 09-01-2007 09:24 AM |
| couple of detail question before I pour the hearth | firepie | Pompeii Oven Construction | 8 | 04-26-2006 03:37 PM |
| Between Hearth SLAB and Hearth BRICKS, slip plane. | Marcel | Newbie Forum | 2 | 09-12-2005 06:35 PM |
| Spanning the wood storage below the Hearth slab. | Marcel | Getting Started | 0 | 08-22-2005 10:13 PM |