Does anyone have a close up top view of the chimney opening being built into the dome oven? Size for opening on a 41 inch dome oven, or at least real good picture of the installation process.
Photos Re: chimney question
(M) I'm not sure if the following link will serve your purpose but try:
(M) Here is a source for my own solution:
http://www.fornobravo.com/forum/f21/...t-5-a-290.html (Marcel's Pompeii Oven photos Part 5 chimney)
(M) My vent picture seems to have been removed from the photoplog.
http://www.fornobravo.com/forum/f21/...t-6-a-413.html (Marcel's Pompeii Oven photos Part 6 stove pipe)
Here it is, again:
"Everything should be made as simple as possible, ...
but no simpler!" (Albert Einstein)
Re: chimney question
I have a few pics of my progress at that point, and could post more if helpful. The opening in my arch is (from memory) 3" x 14". It was actually a little wider than the flue pipe I got and I had to fill the edges a bit. I wanted a smaller opening than the flue itself, after reading about Rumford fireplaces and smoke accelerating through a smaller opening into a larger one.
I don't think I get smoke coming out the front of the oven, and I don't even have a draft door. Interesting because before I put the flue tiles on, smoke just poured out the front. I need to use acid to clean those bricks so that I can truly see if I have any smoke escaping. I'm very happy with it.
I found the flue tiles were much cheaper than chimney pipe as well. Spent something like $70 on the whole chimney.
Vertical pic's of opening:
http://www.fornobravo.com/forum/f8/s....html#post6451 (Saint Helena Oven)
Horizontal Pics of flue pipe going in
http://www.fornobravo.com/forum/f8/s....html#post6471 (Saint Helena Oven)
|Thread||Thread Starter||Forum||Replies||Last Post|
|Chimney options||Yahoo-Archive||Design Styles, Chimneys and Finish||3||10-01-2010 10:18 AM|
|gas fired oven and the chimney question||irishlad||Design Styles, Chimneys and Finish||2||01-15-2007 06:43 PM|
|Chimney Question||mrpbjnance||Design Styles, Chimneys and Finish||2||08-28-2006 09:15 AM|
|Construction of Chimney question||dmun||Design Styles, Chimneys and Finish||0||07-18-2005 08:08 AM|
|Chimney Design question||wlively||Getting Started||1||05-07-2005 06:09 PM|
All times are GMT -7. The time now is 09:07 AM.
Search Engine Friendly URLs by vBSEO 3.6.0
© 2006/10 Forno Bravo, LLC