Re-setting floor tiles Giardino 70
Yesterday, I used a pallet lift to get the dome of my Giardino 70 atop the stand and a friend and wrestled it into place on the FB blanket base/floor tiles. In so doing, several tiles were knocked out of alignment and level. Anyone here had to re-set floor tiles to level with the oven dome in place--or, alternately, jacked up the dome somehow to do this job? If so, any tips greatly appreciated.
Re: Re-setting floor tiles Giardino 70
I just completed a similar operation on my oven. Assuming you set the floor tiles on a bed of sand, just lift out the ones you want to adjust (trowel or strong BBQ spatula works well here), put a bit more sand under them, smooth it a bit then tamp them back to level like you did before the dome was on. You can still get a 3 foot level through the opening to check level front-to-rear, and a shorter one to check side-to-side. I didn't have to remove all of my floor tiles, just one row, but you could re-set them all with the same process.
Last edited by JamieC; 06-12-2012 at 08:21 PM. Reason: typo
|Thread||Thread Starter||Forum||Replies||Last Post|
|Giardino 70 or case2g80, please help||Kevin0422||Modular Refractory Oven Installation||1||05-09-2011 08:12 AM|
|Perilite concrete not setting up--normal?||BarryKeith||Tools, Tips and Techniques||37||02-05-2011 11:40 AM|
|Fireclay vs refractory mortar (for setting oven floor)||Tenorio74||Finding Building Materials||12||01-06-2011 04:49 PM|
|setting up HF saw||morrishuckeba||Getting Started||2||05-19-2010 08:15 PM|
|Setting FB board in fresh concrete||JamesandDeborah||Getting Started||0||04-13-2010 08:28 AM|
All times are GMT -7. The time now is 04:52 AM.
Search Engine Friendly URLs by vBSEO 3.6.0
© 2006/10 Forno Bravo, LLC