| Pizza Ovens | (800) 407-5119 | info@fornobravo.com | U.S. Price List |
|
|
|
#1
11-14-2010, 09:00 AM
| |||
| |||
 Chimney transition Hello All, One step closer to completion now. The clay tile chimney is installed and I've placed brick around it to within a few inches of the top. Should I use Portland mortar to fill the transition to repel water or is there a preferred method and material to put there? It seems like every brick chimney I've seen has cracks and gaps at this "brick to tile" area. I'd just like to do it right before moving on to the next task. I'd appreciate your advice. Cheers  |
|
#2
11-14-2010, 02:55 PM
| ||||
| ||||
| Re: Chimney transition Ordinary portland mortar. If you have a piece of WWF (re-bar mesh) around, take it apart and form a "ring" that you can embed in this layer of mortar. |
|
#3
11-16-2010, 07:47 AM
| |||
| |||
| Re: Chimney transition Thank you Neil2. Cheers, |
 |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Chimney options | Yahoo-Archive | Design Styles, Chimneys and Finish | 3 | 10-01-2010 10:18 AM |
| Storing heat: damper vs. door placed past the chimney? | lancepawl | Forum Guidelines | 3 | 08-31-2010 04:47 PM |
| Chimney and Vent Transition measurements that count | dinoforno | Design Styles, Chimneys and Finish | 10 | 11-17-2009 10:22 AM |
| Chimney transition | Wiley | Design Styles, Chimneys and Finish | 5 | 05-20-2008 09:25 PM |
| Flue Chimney Tips | Alf | Design Styles, Chimneys and Finish | 1 | 08-02-2005 07:07 AM |
Linear Mode
