Wet Saw - Advice Please!
I've been hanging out quietly for a while, gathering knowledge and insight from the awesome builders on the forum. I have most of the materials for my oven project. (Except CalSil board for the hearth) I was all set to go buy the new HF Saw this week so I can start to cut bricks and an opportunity just dropped an "almost free" saw within my reach.
I wanted to get some opinions from the forum - I know folks here have used angle grinders, chisels and such to build beautiful ovens, but I don't see too many "bridge saws".
The pictures that follow show that the head does tilt, so I can bevel my cuts and it has a 10 inch blade - is there any reason to pass on this and go buy a new HF saw?
Thanks in advance!
Mike in Central Florida
|brick saw, bridge saw, wet saw|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Need design advice please||eschneider5||Pompeii Oven Construction||7||11-26-2012 12:13 PM|
|Newbie looking for advice||Denis Li||Introductions||14||09-16-2012 10:17 PM|
|Brick cutting - advice in Australia||Mark CH||Tools, Tips and Techniques||10||02-02-2010 04:28 PM|
|Lake district Italy, some advice?||Karen||Travel||12||06-27-2008 08:06 AM|
|Whats the best advice you recieved here?||Kemo||Pompeii Oven Construction||14||11-18-2007 08:13 AM|
All times are GMT -7. The time now is 05:51 AM.
Search Engine Friendly URLs by vBSEO 3.6.0
© 2006/10 Forno Bravo, LLC