Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Design Styles, Chimneys and Finish (http://www.fornobravo.com/forum/f9/)
-   -   Mounting anchor plate? (http://www.fornobravo.com/forum/f9/mounting-anchor-plate-17661.html)

WJW 04-27-2012 09:06 AM

Mounting anchor plate?
 
I've got a stainless anchor plate which is going to accept an eight inch diameter, double walled, insulated, forty-eight inch tall chimney. The cheminey and ran cap weigh approx. forty pounds total. Anyone have any thoughts about the best weight to mount those plates?

Brick it in?, use masonry-type anchor/screws?

Any help appreciated . Here's what I have to work with:

Chimney and plate just resting in place..
http://img684.imageshack.us/img684/6826/oven106.jpg

Plate just resting there...(looking down from above oven)
http://img839.imageshack.us/img839/4987/oven107.jpg

This is the surface the plate will mount to (also looking down from above the oven...you can see the ash chute in the top of the photo)
http://img100.imageshack.us/img100/7493/oven105.jpg

Thoughts?

Bill

RTflorida 04-27-2012 08:20 PM

Re: Mounting anchor plate?
 
I used blue screws (Tapcons). It's been exactly 5 yrs, never an issue. I'm not sure how you are finishing, I did an igloo. When you factor in insulation, mortar, tile, then a complete refinish over top of that; Mine is encased in at least 8" of mortar, tile and stone...its not going anywhere.

RT

WJW 04-27-2012 09:42 PM

Re: Mounting anchor plate?
 
Thanks RT.

Bill


All times are GMT -7. The time now is 05:31 AM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC