Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Design Styles, Chimneys and Finish (http://www.fornobravo.com/forum/f9/)
-   -   corrugated roofing and chimney flashing question (http://www.fornobravo.com/forum/f9/corrugated-roofing-chimney-flashing-question-8111.html)

splatgirl 10-03-2009 07:30 PM

corrugated roofing and chimney flashing question
 
OK you architectural metals guys...does anyone know the best way to flash my chimney when I'm using corrugated as the roofing material?

splatgirl 10-03-2009 07:43 PM

Re: corrugated roofing and chimney flashing question
 
nevermind. This looks like it will work:

Dektite

david s 10-03-2009 08:32 PM

Re: corrugated roofing and chimney flashing question
 
I think the red ones are more heat resistant, but you probably should have a double skinned flue.

splatgirl 10-03-2009 08:46 PM

Re: corrugated roofing and chimney flashing question
 
I do have the Dura-Vent double wall chimney, but it still gets hot enough that I think I have to go for the silicone version vs. the epdm. Too bad, because it's way more expensive.

MK1 10-04-2009 07:39 PM

Re: corrugated roofing and chimney flashing question
 
If you cut the corrugated to within 1/4" or so you could just silicone caulk the chimney to it. It's nice if the panel seam runs through the opening, easy to layout and cut. If not just measure twice....
If you're lucky or layout the panels so you do have the seam splitting the pipe, also caulk that seam inside the overlap on the uphill side. It won't leak and you won't have ugly orange hi-temp boot to look at or pay for.

Mark


All times are GMT -7. The time now is 03:22 PM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC