Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Design Styles, Chimneys and Finish (http://www.fornobravo.com/forum/f9/)
-   -   Cinderblock to cementboard transition (http://www.fornobravo.com/forum/f9/cinderblock-cementboard-transition-12068.html)

David D 03-09-2010 08:12 AM

Cinderblock to cementboard transition
 
Hello,

I was wondering if anyone who has done the steel framing to box in the oven has had any problem with cracks in a stucco finish? Someone mentioned having the blocks go up to a certain point and then meeting the cement board will cause a crack along the joint.

thanks,

David

Ken524 03-26-2010 10:09 AM

Re: Cinderblock to cementboard transition
 
David,

I did exactly as you described and didn't have any problems with the transition. Make sure you tape the gap between the concrete blocks and cement board. Also, tape ALL cement board seams.

A have a few small stucco cracks in the back of my enclosure where I didn't bother taping the seams (oops).

Good luck!

christo 03-26-2010 01:16 PM

Re: Cinderblock to cementboard transition
 
I did the same - no issues -

I used fiberglass tape at the transistion of the two materials and then used fiber reinforced render to coat the two surfaces (surface bonding cement).

On top of that I put a final coat of a flexible stucco and it's looking great in year two.

Christo

David D 04-13-2010 10:25 AM

Re: Cinderblock to cementboard transition
 
Thanks guys, that makes for a little less worrying on my part, just finished the framing and going to start snapping the hardibacker today.


All times are GMT -7. The time now is 04:33 PM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC