Ryan's 42

[Ryan]

Thanks all. On the question of the slope. All the area around the oven is sloped and drains down to the grass. I had a concrete patio poured, colored, and stamped in the fall. The grade drains water away so the wood storage should be fine. The foundation under the oven slopes a bit as well. I plan on putting an elevated shelf in anyways as the snow can blow in and stack up. That way the would can stay off the floor and stay dry. I will still keep some in the garage just in case! Any suggestions would be appreciated.

Thanks,

Ryan

[gjbingham]

You lost me Ryan. Suggestions for - ??? I read back a page and didn't see any outstanding questions. Maybe I missed something.

[Acoma]

George, I had asked him about slope of his foundation and drainage. He was answering this above.

[gjbingham]

Ahhh, sorry to slow things down. Thanks Robert!

[Ryan]

I was able to cover the dome with the insulating blanket and secure with chicken wire this past weekend. I started framig around the dome with metal studs. I decided to go with the Stone House for the exterior look. I will post some photos this week. Things are all set to start the oven cure. I had to go out of town suddenly on business so, I hope to start the curing process tomorrow. I did have a question?

Can the roof be flat on top or do I need to slightly angle the roof for proper drainage? I don't want to do a gabled roof.

Thanks,

Ryan

[gjbingham]

Flat roof, as in no slope at all? Where in Colorado are you? A slope for rain water or snow sounds advisable.

[DrakeRemoray]

I went with a flat roof after a brief discussion with Cannuck Jim. I put a rubber pond liner down over my durarock but under the flat flagstone stuff I used for the roofing, just in case they do let water in...I was going to do a moderate slope but was afraid that it might just look slightly off...



Drake

[Ryan]

Thanks. I think I might do a flat roof with a slight slope. This would be hidden as I can use a decorative mansard approach. The pond liner is a good idea. I will use that as well.


Thanks,

Ryan

[Ryan]

Here are the photos of the progress I made last Friday and Saturday. I put on the ceramic blanket on Friday. Then went and bought metal studs. I was able to frame up most everything in those 2 days. The photos were taken prior to adding some additional support and bracing with the studs. I was able to apply 3 sides of cement board tonight. It was too dark to take photos as I stopped at 10:15 . There will be more photos tomorrow. Does anyone have a suggestions for a good IR Thermometer? I have been looking online and there are way too many choices.

Thanks,

Ryan

[Frances]

Looking good! Alway surprising how fast the framework goes up... what are your plans for the outside then?

If I were you, I'd go with the FB thermometer - after all, if the plans work as well as they do, I'm sure the thermometer will, too.