Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Pompeii Oven Construction (http://www.fornobravo.com/forum/f8/)
-   -   Insulating blanket (http://www.fornobravo.com/forum/f8/insulating-blanket-16872.html)

gregmorse@bellsouth.net 10-19-2011 06:04 PM

Insulating blanket
 
I am ready to place my insulating blanket and was wondering how to hold it in place until I get the chicken wire mesh installed. I thought about duct tape but was not sure if it could take the heat or if I really needed it?

benguilford 10-19-2011 07:17 PM

Re: Insulating blanket
 
There is probably a very simple way of doing this tucked away in a thread somewhere here, but I just drilled a few holes into my slab and put in some hooked screws using the green plastic 'spaghetti' to fix the screws into the concrete. I spaced these hooks evenly around the perimeter of the dome wall, about 20mm off the brick face. Then I just used some galvanised tie-wire from the local hardware store and fastened the blanket down with that, using the hooks as anchor points. That's one way!

HeidiL2011 10-20-2011 08:06 AM

Re: Insulating blanket
 
Hello Greg,

You can just lay the blankets over the dome. They will not move until you install the the wire mesh.

Thanks,
Heidi

gregmorse@bellsouth.net 10-21-2011 07:46 AM

Re: Insulating blanket
 
Thanks guys for the suggestions; I am getting close and it is very exciting.

Greg:

Neil2 10-21-2011 05:22 PM

Re: Insulating blanket
 
Tie it up with ordinary string. After your chicken wire is in place, cut and pull out the string.

Aegis 10-23-2011 05:19 AM

Re: Insulating blanket
 
I found any of the insulating blankets will stay in place and will have minimal movement. I think I wound up using four different brands, I went with the best deals, (ebay,craigslist,on-line orders) to maximize the amount of insulation. You can never have too much insulation! On the other hand I over spent on safety devices as in a respirator etc. You can never filter the air you breathe too much!


All times are GMT -7. The time now is 03:11 PM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC