Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Pompeii Oven Construction (http://www.fornobravo.com/forum/f8/)
-   -   Firebrick Hearth Uneven (http://www.fornobravo.com/forum/f8/firebrick-hearth-uneven-8813.html)

tdibratt 11-14-2009 05:09 AM

Firebrick Hearth Uneven
 
Hi folks. It's been a while since I have posted on the site. My oven was completed last summer. It's been over a year now of enjoyment with pizza's and breads.

I noticed the other day when I fired it up that some (2) of the bricks just inside the entry way and to the left are not even. My rake and peel catch the edge. I do not remember this being the case when I built it. So my suspicion is that this has developed over the last year or so. I am built on the fibre board (2" thick as I recall).

Is it possible the fibre board has compressed and has caused this to happen?

Post #14 in my thread shows the picture:

http://www.fornobravo.com/forum/8/to...ld-4678-2.html

Should I worry about this?

Neil2 11-14-2009 04:57 PM

Re: Firebrick Hearth Uneven
 
"My rake and peel catch the edge."

If you have an angle grider, just trim the edges back a bit.

"Should I worry about this?"

Not unless there is some sort of structural failure (examine your suspended slab closely for cracking.)


All times are GMT -7. The time now is 03:53 PM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC