Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Introductions (http://www.fornobravo.com/forum/f3/)
-   -   Getting ready to start...Finally (http://www.fornobravo.com/forum/f3/getting-ready-start-finally-12834.html)

Fenton 05-02-2010 03:58 PM

Getting ready to start...Finally
 
Hello...
I'm new on the forum and I'm still getting used to it. I finally broke ground for my oven but I have a question. I'm in Michigan and our frost line is 42". I was going to do footers at this depth and then cement block to ground level. I was wondering if the block should be coated with anything and what should i fill the inside with? Gravel? the dirt I took out ?or a combination of both? I'm putting a slab on top of the block and then will continue the base from there.
Thanks for any help you can provide.

Tscarborough 05-02-2010 04:00 PM

Re: Getting ready to start...Finally
 
Concrete at the corners and every third or fourth cell, preferably with at least a #3 rebar vertically though the footer.

Fenton 05-02-2010 04:05 PM

Re: Getting ready to start...Finally
 
Thanks, I was really worried about movement. After all the planning, the wife would kill me if it heaved and cracked....

Tscarborough 05-02-2010 04:10 PM

Re: Getting ready to start...Finally
 
Wait for more and better responses, the only frost heave around here is from eating too much ice cream. Going by some of the pictures I have seen posted, my recommendation is light on reinforcement.

ThisOldGarageNJ 05-03-2010 04:53 AM

Re: Getting ready to start...Finally
 
Hi Fenton and welcome....
If you check with the local building dept, they may have recommendations.. I like the flared sonotubes.. makes it almost impossible for frost heave... also allow for drainage around your slab..... If you like, and go the block route,, In addition to what scar said, you can coat the block with SBC (surface bonding cement) and add the acrylic fortifier for additional waterproofing.. Welcome and good luck with your build
Cheers
Mark


All times are GMT -7. The time now is 12:01 AM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC