Forno Bravo Forum: The Wood-Fired Oven Community

Forno Bravo Forum: The Wood-Fired Oven Community (http://www.fornobravo.com/forum/)
-   Newbie Forum (http://www.fornobravo.com/forum/f2/)
-   -   Public Spreadsheets ? (http://www.fornobravo.com/forum/f2/public-spreadsheets-5428.html)

staestc 10-28-2008 02:31 PM

Public Spreadsheets ?
 
How are you folks publishing spread sheets of costs so that there is a URL that anybody can get to them?

I think I have read something about using Google, but I did not know Google provided anything like that, so how do I get to it?

Thanks,
Travis

Ken524 10-28-2008 09:05 PM

Re: Public Spreadsheets ?
 
Check out my spreadsheet link below. Google Documents lets you publish public spreadsheets.

staestc 10-29-2008 04:44 AM

Re: Public Spreadsheets ?
 
Thanks Ken, much appreciated.
Travis

staestc 10-31-2008 03:29 AM

Re: Public Spreadsheets ?
 
Ken,

Video slide show is very well done too! Are you going to extend it for the enclosure, or have you already?

Travis

staestc 11-02-2008 07:51 AM

Re: Public Spreadsheets ?
 
I have created a nifty spread sheet on the google site, but I cannot figure out how to make it available to people without them having to log into google.

I can publish the link that I use:
Test Sheet

But I seem to have to log in when I try to use this. Ken's link has "pub?key=..." in it, while mine has "ccc?key=...".

How do I make my nifty sheet available for folks to look at? :confused:

Thanks,
Travis

Ken524 11-02-2008 05:16 PM

Re: Public Spreadsheets ?
 
Quote:

Originally Posted by staestc (Post 44007)
How do I make my nifty sheet available for folks to look at? :confused:

Travis,

Take a look at your spreadsheet. In the upper right corner there is a box that says "Share". Click that box then click "Share with the world". That should get you started in the right direction.

Ken

Ken524 11-02-2008 05:17 PM

Re: Public Spreadsheets ?
 
Quote:

Originally Posted by staestc (Post 43851)
Video slide show is very well done too! Are you going to extend it for the enclosure, or have you already?

Thanks! Yes, I'm planning on "finishing" the video. Probably when it starts getting too cold to be in the garage working on my pickup truck :)


All times are GMT -7. The time now is 09:13 PM.

Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
2006/10 Forno Bravo, LLC