web analytics
Novice concrete question - Forno Bravo Forum: The Wood-Fired Oven Community

Announcement

Collapse
1 of 2 < >

Forum Issues Update

We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
2 of 2 < >

Dome Installation Video - Casa / Premio / Modena

Hello,

For many of you who bought a modular oven, you may have asked how we put the domes together when we build them. For those of you considering one of our ovens, we shot a video to make your install easier.

Check it out on our You Tube Channel.

https://www.youtube.com/watch?v=-7q7...jSniYogfUra06Q

If the link doesn't work, simply go to You Tube and type Forno Bravo Channel. The video title is How to Set your Forno Bravo Oven Dome Pieces.

Thanks for participating in our Forum. We will have more video content available soon.
See more
See less

Novice concrete question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Novice concrete question

    When "floating" the foundation and/or hearth after screeding it with a 2x4, do I need to use a metal float or is a piece of wood with a handle on it sufficient? Does it make any difference structurally (does one draw water to the surface more or less than the other, and is that a good or bad thing?) or is it purely aesthetic with regard to the appearance and texture of the concrete (in which case I'll probably just go with the wood since I don't care what the concrete looks like, I'll probably flagstone it later anyway.).

    Thoughts?

    Website: http://keithwiley.com
    WFO Webpage: http://keithwiley.com/brickPizzaOven.shtml
    Thread: http://www.fornobravo.com/forum/f21/...ttle-7878.html

  • #2
    Re: Novice concrete question

    You are good to just screed it off. If all goes well, there should be no water there to be of concern. I left mine rough as well, my thinking was that the mortar would adhere to it better.

    Les...
    Check out my pictures here:
    http://www.fornobravo.com/forum/f8/les-build-4207.html

    If at first you don't succeed... Skydiving isn't for you.

    Comment


    • #3
      Re: Novice concrete question

      kebwi
      after you screed it off with your 4x2, that gets it flat and level but with a rough finish.
      Sure it is non slip but if you want it nicer, easier to sweep or mop, flatter for tiling etc. then you need to use a concreting float. A wooden one held flat and used in a circular motion can push the agregate a little lower (when the concrete is wet and soft) and will not bring the water to the surface. A steel trowel on the other hand will bring the water out of the concrete (which won't hurt apart from possibly leaving water marks on the surface). To get the smoother finish hold up the leading edge of the trowel and when the cement is hard enough to walk on without leaving indentations, use a sweeping motion to get that super smooth finish.
      If you have excess water, then make up a 1 part portland and 1 part concrete sand mix and sprinkle it over the surface, work it into a slurry with your flat trowel and then when it is a little drier, float it our with your steel trowel. You can add some coloured oxide to the mix to put a coloured surface on your concrete but follow the instructions on the oxide container.

      Good luck and watck your back.

      Chers.

      Neill
      Prevention is better than cure, - do it right the first time!

      The more I learn, the more I realise how little I know


      Neillís Pompeiii #1
      http://www.fornobravo.com/forum/f8/n...-1-a-2005.html
      Neillís kitchen underway
      http://www.fornobravo.com/forum/f35/...rway-4591.html

      Comment


      • #4
        Re: Novice concrete question

        Thanks. I always appreciate the thorough advice.

        Cheers!

        Website: http://keithwiley.com
        WFO Webpage: http://keithwiley.com/brickPizzaOven.shtml
        Thread: http://www.fornobravo.com/forum/f21/...ttle-7878.html

        Comment

        Working...
        X