web analytics
how are you notching your bricks - Forno Bravo Forum: The Wood-Fired Oven Community


1 of 2 < >

Forno Bravo Forum Thread Message

Hello, Forno Bravo Community Forum Members!

The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.

Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.

We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.

Thank you for all of your patience and continued support.

Link to topic: http://www.fornobravo.com/community/...with-new-forum
2 of 2 < >

Dome Installation Video - Casa / Premio / Modena


For many of you who bought a modular oven, you may have asked how we put the domes together when we build them. For those of you considering one of our ovens, we shot a video to make your install easier.

Check it out on our You Tube Channel.


If the link doesn't work, simply go to You Tube and type Forno Bravo Channel. The video title is How to Set your Forno Bravo Oven Dome Pieces.

Thanks for participating in our Forum. We will have more video content available soon.
See more
See less

how are you notching your bricks

  • Filter
  • Time
  • Show
Clear All
new posts

  • how are you notching your bricks

    trying to figure the best way to make small cuts with the HF saw, specifically trying to make the notch for the door to lean against, some refer to this as the pistol cut. is there a trick since with the 10 in round blade its hard to make a 1/2 inch cut

  • #2
    Re: how are you notching your bricks

    The only cuts that are hard to make are the really deep cuts, sometimes you have to score those on both side, break off the segment, and trim it freehand. The shallow half inch cut you're taking about, you can just mark the line with a waterproof marker, and pull the table away and cut it freehand. This presupposes that you're using an unsegmented diamond blade where brushing against the blade won't be a disaster.
    My geodesic oven project: part 1, part 2


    • #3
      Re: how are you notching your bricks

      that is what I thought, yes smooth blade, will need to watch my fingers still


      • #4
        Re: how are you notching your bricks

        I ran a cut to the depth I needed. I was using a HF saw so I could raise the blade to make the second cut (of the pistol). On the really long cuts I believe I ended up using the blade as a "mil" to finish the cut. You can see the results here. PhotoPlog - Uploads Posted By Les
        Good luck,

        Check out my pictures here:

        If at first you don't succeed... Skydiving isn't for you.