web analytics
Firebrick Hearth Uneven - Forno Bravo Forum: The Wood-Fired Oven Community

Announcement

Collapse

Forum Issues Update

We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
See more
See less

Firebrick Hearth Uneven

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Firebrick Hearth Uneven

    Hi folks. It's been a while since I have posted on the site. My oven was completed last summer. It's been over a year now of enjoyment with pizza's and breads.

    I noticed the other day when I fired it up that some (2) of the bricks just inside the entry way and to the left are not even. My rake and peel catch the edge. I do not remember this being the case when I built it. So my suspicion is that this has developed over the last year or so. I am built on the fibre board (2" thick as I recall).

    Is it possible the fibre board has compressed and has caused this to happen?

    Post #14 in my thread shows the picture:

    http://www.fornobravo.com/forum/8/to...ld-4678-2.html

    Should I worry about this?
    Check out my build at:
    http://www.fornobravo.com/forum/f8/t...uild-4678.html

  • #2
    Re: Firebrick Hearth Uneven

    "My rake and peel catch the edge."

    If you have an angle grider, just trim the edges back a bit.

    "Should I worry about this?"

    Not unless there is some sort of structural failure (examine your suspended slab closely for cracking.)

    Comment

    Working...
    X