If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forum Issues Update
We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
I used a thin layer of heat morter to adhere the first layer of blanket to the dome. It worked really well. If you're doing a second layer - that's a different story. I used chicken wire to hold the blanket in place but be careful.....the fricken wire kept cutting me. Be patient and don't swear too loud as the neighbours will start complaining!! In my opinion, this was the most frusterating thing out of the whole build. Good luck. ~Joe
I was given a very long length of kevlar measuring tape, like the kind surveyors use. It had become damaged at the "dumb" end and so I was given it for free. Kevlar is used for many things: it is extremely strong and as such is used in bullet proof and slash/stab proof clothing; it is also resistant to temps up to about 1000F and is used in fancy hi heat gloves used by glass blowers. You can perhaps talk your local power crew or telephone guy into donating a length as it is used as pull line for pulling wire thru conduit (often really really long lengths!). It is gold in color and shiny so that should help in recognizing it. As pulling line it is often a flat woven tape. I didn't find I needed that much here are three photos of the steps of my blanket insulation: