If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
1 of 3<>
Forum Page Loading Response
We have received feedback regarding recent issues with page loading response time. We believe the slow response issue stems from the analytics we added with the new Forum. We are in the process of reconfiguring those elements and, after an approximate 24-hour time period for the reconfiguration to run, we anticipate a return to normal page load times. Thank you for your patience!
2 of 3<>
Hello, Forno Bravo Community Forum members.
As many may have noticed already, the Community Forum site was briefly down today. While working on scheduled routine maintenance, we encountered an error when trying to add a software update. As the site is now back up and running, some of you may notice that some recent data has been misplaced from November 10th up to today. We are currently working on resolving the issue. The forum has full operational capabilities and we encourage all forum members to continue actively posting in the threads.
We apologize for any inconvenience that this issue may have caused you. The Forno Bravo family values each and every member of our community. If you have any issues or concerns, please feel free to let us know on our issues thread here:
The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.
Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.
We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.
Thank you for all of your patience and continued support.
the area of your dome should be close to a half that of a spere, in your case the outside dimensions rather than using the inside 31" dimension. Add your wall thickness and do the following calculation"
The surface area of a sphere of radius 'r' is given by:
surface area = 4pr2
NOTE: The value of p can never be known exactly, so surface areas of spheres cannot be calculated exactly. Common approximations for p are: 3.14, and 22/7.
You normally get a specific area in a carton/package of insulating wool and this will vary from manufacturer to manufacturer and will vary again if it is 1" or 2" thick
2" od superwool is the same equivalent as 4" vermiculite cement which is deemed as the minimum needed for a WFO. My 40" Pompeii has i" superwool and 3" vermiculite cement and when the oven is over 500˚C inside, the outside dome is cold.
Prevention is better than cure, - do it right the first time!
The more I learn, the more I realise how little I know