web analytics
Initial firing heat temps - Forno Bravo Forum: The Wood-Fired Oven Community

Announcement

Collapse

Photo Galleries are back! Instructions below.

Dear forum users,
Thank you for your patience with the Photo galleries. We've got your galleries online!
We have finished writing a custom script to migrate the PhotoPlog to vBulletin5’s albums.

Unfortunately V-Bulletin killed the "Photoplogs" in their software upgrade which was unforeseen and we're the first development group to have written a script for getting the galleries back... that said, it took some time to reverse engineer the code and get the albums to move over seamlessly!

Forum users will be able to access their “PhotoPlog” images through their user profile page by clicking on the “Media” tab.
They will also be able to browse other albums by going to the albums page. (On the forum site, there is a link in the black bar beside “Forums” to the albums.)

In order for users to create an album please follow the steps below.
1) Go to user profile page and click “Media”
2) Click Add Photos
3) Enter Photo Gallery Title in the first field
4) Click Upload or Select from Photo Album to add photos
5) Click Post
6) Once posted, the album will be created as a “Topic” on the albums page for the public to see. The topic title will be the “Photo Gallery Title” they created before uploading their photos.


To create this migration path we used vBulletin5’s default album structure. Unfortunately, it won’t work like the “PhotoPlog” but is an album/gallery component on the forum now.
See more
See less

Initial firing heat temps

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Initial firing heat temps

    Im hoping all of you with thermocouples can help me with this, and since I havent seen it discussed thought it might be interesting.

    Im trying to figure out what cuts would be ideal in a cast dome in order to reduce cracking. Since I theorize most cracks are due to the temperature differential that occurs durring firing I would like to know how the oven heats. Which areas get hot first, and how the heat spreads. Its my theory that the top of the oven gets hottest first and it gradually spreads to the dome to hearth contact point.

    Since I dont have thermocouples mounted I cant confirm though. Has anyone ever mapped the progression of heat throught the oven body?

  • #2
    Re: Initial firing heat temps

    Yes, as a matter of fact mine has TC's. I have only made one data chart so far. I started collecting temps after we had baked our first pizza's, so the starting temp is after 2.5 hours of hard firing and then baking the pizza.

    Copy from my oven post:
    I have 3 thermocouples all imbedded into the approx center of the bricks. One in the very top center of the brick in the middle of my dome plug, one about halfway down the dome, and one drilled sideways about 9 inches into the floor. If you look closely you can see them in a previous picture. The only data taken so far was my the coast down from the first pzza bake. The curves are very interesting, in that the top temp gradually falls from 594F -223 over 29 hours. The middle actually increased in temp for (382-399) the first 2 hours, then ended up at 226. The bottom rose for 1 hour (312-320) then ended at 177. Interesting that both dome TC's ended up only 3 degrees apart, which makes sense, but good to see. These temps are without a door or anything covering the entry. I have the graph but can't get it sized right to post. I expect the curve to flatten out a bit more over time.
    Wade Lively

    Comment

    Working...
    X