If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forum Issues Update
We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
One thing that was suggested when I cured was to loosely cover the dome with the CF while curing to help equalize the the temperature from the inside to the outside. I did not out of forgetfulness but not a bad idea and nothing to loose.
Isnt enamel just the finish? If so you can even apply engine enamel from a spray can.
I think it's dipped and then oven baked. I don't know about engine paint would it be hard to spray the inside of a 6 in steel tube. I now have a mental picture of someone's arm up the elbow in a steel tube with a spray can. Recon one of those gloves that they use to inseminate cows. I'm not letting this thought go any further.....
Fit in position with largest hammer