If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forum Issues Update
We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
Yes it is OK, if fact it is a really good idea, because although you don't really need to retain the heat in the flue and the entry it will both support the structure and reduce the temperature differential between the inside and the outside which can be damaging.
I laid my decorative brick about an inch from the flue pipe and worked the vermiculite / portland in between the two. You are obviously using a form so what is your plan on the finish? The route you are going, you could pretty much do anything. Great idea, opens up a LOT of potential.
The forms are off. I am thinking of a enclosure les, i v/p the vent for structure and insulation purpose. I am pretty much winging it, i have been making up ideas as i go on, every time i have a idea i change it anyway,lol...so will see where it goes from here.