If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forno Bravo Forum Thread Message
Hello, Forno Bravo Community Forum Members!
The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.
Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.
We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.
Thank you for all of your patience and continued support.
i am building an alan scott oven and was wondering if i should use the fireclay mortar mix (10 - 3 - 1-1/2) or just type s mortar for building the chimney. any ideas on which would be the better choice?
I'd stick with the fireclay mix as the Portland cannot withstand the higher temperatures.
I know that it's a chimney that you are referring to, but they still get pretty hot.
Go the safe way rather than inviting problems to your build.
If you don't succeed the first time, try again and again until you get it right!