If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
1 of 2<>
Hello, Forno Bravo Community Forum members.
As many may have noticed already, the Community Forum site was briefly down today. While working on scheduled routine maintenance, we encountered an error when trying to add a software update. As the site is now back up and running, some of you may notice that some recent data has been misplaced from November 10th up to today. We are currently working on resolving the issue. The forum has full operational capabilities and we encourage all forum members to continue actively posting in the threads.
We apologize for any inconvenience that this issue may have caused you. The Forno Bravo family values each and every member of our community. If you have any issues or concerns, please feel free to let us know on our issues thread here:
The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.
Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.
We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.
Thank you for all of your patience and continued support.
42" Dia. will work on 4 & 1/2 concrete blocks to a side
(M)Hi, Steve, I wrote on an earlier thread which relates to insulation:
(M) The most important first decision I had to make was whether I would enclose my Pompeii igloo with house walls made of cement board. I feel that this is so important an early decision that I am also going to post this message on the Newbie Forum.
(M) The reason this 1st decision is so important is that when I decided to enclose my igloo (permitting me to add lots of perlite insulation under the roof) I realized that it would be a waste of time to do fine finish detail work that would ultimately be hidden. Paul and Robert are just two builders that opted for elegant detail. Robert with his mosaic, and Paul with his arched brick throat entry.
(M) My recommendation to any Newbie is to make that 1st decision before you do any work! I struggled trying to reconcile different photos and directions until I realized that there is a fundamental structural process to be considered which is based on that 1st choice.
(M) My hearth stand has 4 1/2 concrete blocks to a side and supports a 42 igloo. Because of how the courses are normally staggered there is no need to cut any blocks. The blocks are a nominal 8 x 16 inches but in reality they are slightly smaller to allow for a morter line.
(M) If you want to see the initial construction phase of that stand, with comments on size, go to