If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forum Issues Update
We are continuing to work diligently to resolve the issues currently being experienced with the PhotoPlog. Thank you for your patience!
Just double up and off-set some 1/4" hardware cloth, bend the four edges at a 90* (around 2" ) then push it down until it sits flush with the top of the flue. Then cap as planned...all chimneys should be capped, not exceptions.