If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Forno Bravo Forum Thread Message
Hello, Forno Bravo Community Forum Members!
The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.
Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.
We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.
Thank you for all of your patience and continued support.
is there no one who can comment on this. I really want to get my order in. Perhaps I misread the directions. It does look like the better builders have used an 8 inch, but it is hard to tell from the photos. Thanks for your input.
Here is a picture of my 42 inch oven with a DuraVent anchor plate, 30 degre elbow, 48" straight section and then another 30 degree elbow. It draws like a steam train! The picture without the metal frame was a test run to see how well it ventedut the 30 degree set-up. There was no difference so I went with the set-up shown behind the metal framed enclosure which is the set-up I explained above...
PizzaBob, I have a question. My vent is under my newly constructed roof, and I could go straight up thru it, or do the 30 degree kit and angle it like you did and then I wouldn't have to cut my roof. You on the other hand seem to have a oven out in the open, and now you are using the metal framing around the oven. Why didn't you just go straight up, instead of the 30 degree thing. It obviously would have been cheaper and perhaps a better draw.
The ONLY reason I went with the 30 degrees was to get the vent to the center of the roof. The roof is a "hipped-roof" which has four angles that create a flat in the center of the enclosure. It's purely cosmetics as to why I used the 30 degrees. I wanted the vent to come out the center of the flat portion of the roof as opposed to coming through the angled portion. It seems to draw really well. If I need to I can add an additional straight section to the top to make it taller. But for now it seems okay.
My concern now is.....I used DensGlass (Georgia Pacific) as the enclosure. It's called DensGlass Fireguard (5/8" thick). I thought it would be fireproof but I called Georgia Pacific and they don't recommend haeting it over 125F! I have so much insulation (3" ceramic and then all loose vermiculite within the enclosure) so I'm not concerned about the walls or ceiling getting anywhere near 125F but the area around the front arch I believe will get over 125F! They said it's not flamable but gypsum is made up of 20% water and repeated temps of 125F can start to dry it out and may crumble.....UGH! The enclosure was just finished today!