web analytics
Will this work for a stand - Forno Bravo Forum: The Wood-Fired Oven Community



Forno Bravo Forum Thread Message

Hello, Forno Bravo Community Forum Members!

The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.

Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.

We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.

Thank you for all of your patience and continued support.

Link to topic: http://www.fornobravo.com/community/...with-new-forum
See more
See less

Will this work for a stand

  • Filter
  • Time
  • Show
Clear All
new posts

  • Will this work for a stand

    Hi everyone.
    I'm still in the planning stage and want to run something by those with more knowledge about structural strengths of stands etc.
    I have a heap of 110W 390L 190H concrete blocks.
    I would like to know if they are suitable to use without having to double them up. Here is a very rough drawing of the shape of the stand. I will double them up at the ends as you can see and they will be 4 blocks high with a brick curtain at the top.
    Hope this makes sense.
    Attached Files

  • #2
    Re: Will this work for a stand

    For those who don't speak French: the blocks are 4.3" wide, 15.3" long and 7.5" high.

    They will work fine, I don't even think you need the front-to-back wall, one cross wall should be support enough.

    The reason we don't use what we call 4x8x16 blocks more in the US is that you can't do the dry-stack-and-fill method, as the cavities are too small. Mortaring block walls is a bit of a challenge for masonry novices. This tool makes the job a little bit easier.
    My geodesic oven project: part 1, part 2


    • #3
      Re: Will this work for a stand

      Thanks for the reply guys I really appreciate it.
      So it looks like I can use them but I'm just a little confused about using bricks for the curtain/boarder as it will weaken the joints as you say Doug. Are you saying this because the bricks must sit on the blocks therefore reducing the amount of slab that'll be resting there. If so the bricks I plan on using are 50mm wide and I was going to have them sitting 30mm on the blocks and 20mm overhanging. That'll leave 80mm for the slab to make contact with the blocks and rest on.
      Is this enough or should I drop the brick idea and think of another way of decorating the slab. That's all it really was just a way of making it look nice.
      I can always tile around the slab with terracotta or similar.
      Thanks again guys I love this site.


      • #4
        Re: Will this work for a stand

        Hi Doug

        The opening will be at the bottom of the pic which has the two spaces side by side. I am going to put shelves in there and a couple of doors. The side openings will be were I store the wood. Might also put doors there to keep the weather out.
        Can't wait to start this build but as we have christmas at our house this year I'm not aloud to start until christmas is over