web analytics
Starting fire with Natural Gas Assistance - Forno Bravo Forum: The Wood-Fired Oven Community



Forno Bravo Forum Thread Message

Hello, Forno Bravo Community Forum Members!

The Forno Bravo team has heard the feedback in regards to the community forum. We wanted to take the time to re-enforce our commitment to a fully engaged Forum with professional moderation.

Our top priority as a company is to fix all forum errors and issues that you are experiencing. As we are swiftly working on these problems, we want to say that we highly value the Forum Bravo Community Forum and every single community forum member.

We have set up this thread so that every member can address any concerns, issues and questions about the forum. Please feel free to ask whatever you would like in regards to the forum; let us know what issues you are experiencing so we can work on resolving them as fast as possible. However, we stress that we would like constructive engagement, so please be specific about the issue you are experiencing.

Thank you for all of your patience and continued support.

Link to topic: http://www.fornobravo.com/community/...with-new-forum
See more
See less

Starting fire with Natural Gas Assistance

  • Filter
  • Time
  • Show
Clear All
new posts

  • Starting fire with Natural Gas Assistance

    I am planning construction of a 42" oven the summer and I am considering piping in natural gas into the back of the oven, up through the oven floor. I would install a permanent, orifice pipe in the back of the oven to help light/strart fires. I was considering installing the gas shut-off into the front of the stand for ease of turning on/off the gas flow.

    Does anyone know if this is a bad idea, or just plain overkill? I know it is done routinely for indoor fireplaces, however, I think this oven will get much hotter than a fireplace.


  • #2
    Re: Starting fire with Natural Gas Assistance

    Hey Dwight,

    Piping gas into an enclosed space can bring a fair share of risk. With the enclosed space of a pizza oven, any 'extra' gas (slow leak, or you waited a bit to long with the gas running before adding a match) can 'blow up' and make a mess of things. In a fire place, 'extra gas' is less of a concern.

    Unless you are prepared to install appropriate safety systems on the gas line, it can add more problems than it solves.

    As a general rule, you will want to use dry wood for your fires (all around better results than wet wood). And if you are using dry wood, it doesn't take much time to get past the 'start a fire' stage to the 'keep a fire going strong' phase.

    We have seen some fella's use a propane powered 'weed burner' to kick start the fire with good reports. Not as clean an installation as a permanently installed fire starter, but it speeds up the oven firing work.

    There obviously are some ovens that run exclusively on gas, but I think they include a fair amount of engineering to support that fuel source.

    So, I guess my report is that it can be done, but generally if you have an interest in doing it safely and not creating a situation that will go 'bang' in the back yard, it is best to stay away from the gas in the oven.

    Good luck with your build.



    • #3
      Re: Starting fire with Natural Gas Assistance

      I agree with Jed.

      Besides, starting a fire is not that difficult.


      • #4
        Re: Starting fire with Natural Gas Assistance


        I had a feeling someone would give this advice; it makes sense. I will stick with matches.


        • #5
          Re: Starting fire with Natural Gas Assistance

          One of the better practices that may help you (if you haven't seen it elsewhere on this site) is to load most of the wood for the next fire in the oven while it is still warm. The residual heat can do a lot to dry out the wood and make it especially easy to start the next fire. Also, if you don't have much fire starting experience, a bit of reading on kindling techniques can help a lot.

          As I use a lot of juniper, I actually start most of my fires by simply igniting juniper branches with dry leaves. The stuff burns like greasewood so I have it easy compared to most of you when it comes to starting fires!

          Good Luck!


          • #6
            Re: Starting fire with Natural Gas Assistance

            I get a roaring fire in about 3 minutes with a dry stack of wood and one "Fatwood" stick (Fatwood Natural Fire Starter) available at Lowes/Home Depot/Walmart. No newspaper, no fuss.

            Save the gas for your grill .
            Ken H. - Kentucky
            42" Pompeii

            Pompeii Oven Construction Video Updated!

            Oven Thread ... Enclosure Thread
            Cost Spreadsheet ... Picasa Web Album